Feeler: 1994 ext cab 1500 w/ 2002 5.3/4l60E installed - Central Florida

[SpecV44]

Earlier I started thinkin bout what this truck needs and I came up with some questions...



So these aren't hooked up right now?
Are the speedo output and volt meter wires still in the 02 harness?
Are the coolant temp and oil pressure wires still left from the 94 harness?
The fuel gauge wiring was left untampered with right?
Is the AC hooked up and working?

Speedo output is there, not sure what volt meter wires you are referring to. not many wires were removed from the harness, only things that I KNEW werent going to be used were removed.

Coolant was screwed up completely when I bought the truck, they melted the sender and wire, then hacked it up trying to get it to work, so it was deleted. I will have to check, but I think I accidently deleted the oil pressure on the truck side. I was kicking myself when I couldnt find it before.

Fuel gauge worked up until I dropped the tank, I am 99% sure it is a ground, I will get it working before anything happens though.

AC is notched, compressor installed, need lines made from compressor to condensor and to the evap. I have the full AC system from the 2002, so they just need put together. The AC worked with the TBI, so I am sure it will work again once lines are made.

Like I said, the major stuff is done, but I want to make you aware of everything, and I understand if at any time you want to back out. I just want to answer any questions I can to ensure you get as much information as you need.