2000 silverado running bad

[rat454]

Checked fuel pressure. 50psi at idle and the pressure would rise as I gave it gas. i removed the vaccum reference from the regulator and the pressure immediately went to 60psi. So, I don't think its a fuel problem but this doesn't explain the reduced fuel mileage.
Checked the alternator wires and looked fine. The volt gage always reads around 14v. Never seen is fluctuate.
The truck seems to running better but not 100%. Maybe I got a bad tank of gas. The tank it ran the worst on was 93 octane Chevron, where I buy from often. Wonder if since the economy is not so good these days no one is buying 93 and the gas is going sour.
cleared the dtcs and will check later today.

[txarkitekt]

Checked fuel pressure. 50psi at idle and the pressure would rise as I gave it gas. i removed the vaccum reference from the regulator and the pressure immediately went to 60psi. So, I don't think its a fuel problem but this doesn't explain the reduced fuel mileage.
Checked the alternator wires and looked fine. The volt gage always reads around 14v. Never seen is fluctuate.
The truck seems to running better but not 100%. Maybe I got a bad tank of gas. The tank it ran the worst on was 93 octane Chevron, where I buy from often. Wonder if since the economy is not so good these days no one is buying 93 and the gas is going sour.
cleared the dtcs and will check later today.

Ok, fuel psi is fine. FPR is fine. No prob there. How old is the fuel filter? They are cheap and easy to replace.

Alt may be OK. Visual inspection won't cut it. Use a voltmeter to check to see if wires are reading correctly.

Gas could be the problem, but it going sour? Highly doubt it since Chevron is some of the best gas around and is Top Tier Rated.

Change fuel filter, run 93 octane with Chevron Fuel System Cleaner (run it slightly rich..as in one bottle for like 12 gallons of fuel), and drive it like you stole it until that tank is empty. Then report back.

[rat454]

I have run a rich mixture of lucas gas treatment twice and ran it hard with no significant change. I pulled all of the plugs and ohmed each plug wire. All wires measured very close to the same number on my multimeter and all plugs looked the same with no fowling or closed gaps etc. i cleaned the maf with correct cleaner. I took the egr valve off and checked to see if the valve would open freely and it did and visualy inspect it. While I had it off I blew it out with compressed air. The truck seemed to repsond positively to this but I still have a slight hesitation off idle and the truck bucks when applying gas (enough to accelerate but not enough to go into 3rd gear(=) at low rpm in overdrive. Also at wot the truck skips.
I unhooked the egr connection and no difference. I checked live data during my drive to work today. map, iat, maf, tps, knock sensor, spark advance, values seemed ok and would respond accordingly to rpm change and engine load.
Anyone have any ideas?