i have an HD2 shift kit, what size drill bit do i use to get the truck to shift firm at part throttle and firm at WOT? i dont want the truck to break my neck when it shifts into 2nd gear. the only thing i have is billet 1-2 servos and a TB Stall.
i have an HD2 shift kit, what size drill bit do i use to get the truck to shift firm at part throttle and firm at WOT? i dont want the truck to break my neck when it shifts into 2nd gear. the only thing i have is billet 1-2 servos and a TB Stall.
2008 GMC CCSB 6.2/6L80e swap
Gen IV 5.3/60e swap 1994 ecsb W/T
Buy a new transgo seperator plate and put it in stock to start with to see if you like the feel. You can drop it out and open the passages a little later if you don't like how the shifts feel. You might consider some new torlon check balls, too. Be sure to check all holes in the plate and deburr any sharp edges on the new plate. Add a drain plug to the pan if you don't have one already.
See my truck data in the "My Garage" section here... http://www.ls1truck.com/forums/my-ga...tml#post191709
Posting Permissions
Reply With Quote