where are you from exacly?Originally Posted by Lsx10
where are you from exacly?
I'm from tucson az, the northwest side.
s10 with 4l60e and cammed 5.3 on the road!THREAD
"People sleep peaceably in their beds at night only because rough men stand ready to do violence on their behalf.".
long overdue update
well school started and she isn't running yet. so close but so far
Hooked up the walbro into my stock sending unit, I ran the fuel lines to the filter, still need to run the last line to the engine.
and now to announce change number 793
I got another new intake! My buddy had an issue with it and was pressed for time so I swapped him my ls6 intake for this baby. I dont have any pictures of it when I first got it, the first thing I did was clean it up and paint it the same color as the last 2 I had.
then instead of getting the 85mm tb I ported the intake out to a 90mm and picked up a bluemaxxx 90mm. there are more wet kit options and it should be worth a few ponies.
more to come soon, hopefully...
s10 with 4l60e and cammed 5.3 on the road!THREAD
"People sleep peaceably in their beds at night only because rough men stand ready to do violence on their behalf.".
is that a professional products intake? Does it use paper gaskets to seat to the heads? If so, they're notorious for vacuum leaks. Make sure everything seats up correctly since the mating surfaces have trouble aligning. Silicone may be your only hope of getting no intake vacuum leaks if its a PP intake.
See my truck data in the "My Garage" section here... http://www.ls1truck.com/forums/my-ga...tml#post191709
Posting Permissions
Reply With Quote
