Motor Mounts & E-Fans?

[pcmcobra]

I used the carshopinc plates off ebay, worked fine.
I am running ls1 fans, but right now they are controlled by a flexalite controller, as soon as I stop being lazy I will wire them up to the pcm with some relays.

[RedHeartbeat]

Nelson Performance makes a harness for pretty much any fan configuration. I used plates like the ones you mentioned on all my conversions. The Hooker plates look more user friendly, like the bolts would go through the mount without having to pry one out of location to get the bolt through. I always have to use the hoist to twist the 1st mount out of location so that the 2nd bolt can be installed.

[quickblue6]

Nelson Performance makes a harness for pretty much any fan configuration. I used plates like the ones you mentioned on all my conversions. The Hooker plates look more user friendly, like the bolts would go through the mount without having to pry one out of location to get the bolt through. I always have to use the hoist to twist the 1st mount out of location so that the 2nd bolt can be installed.

You have a link to those mounts by Hooker?

[RedHeartbeat]

eBay Motors: Hooker 12611 LS1 Engine Swap Adapter Plates JEGS (item 350164135700 end time Mar-10-09 19:22:17 PDT)