Nice little scooter!
Nice little scooter!
'86 Silvy- '06 6.0/4L80E, K&N, 2.5 X-pipe Magnaflows, 20" Foose Wheels, Auburn Pro, 3.90 Richmond Gears, and the list is growing!!!
top three bolts, take the intake off and attack from the top or remove crossmember and let trans hang, get a very long extension to get the top bolts. Converter bolts are easy, 3/8 ratchet in the hole where the starter was. Roll the crank around until the bolt is just below the starter mount and then put the ratchet to it. I put a deep socket on the handle end with an extension for more leverage.
See my truck data in the "My Garage" section here... http://www.ls1truck.com/forums/my-ga...tml#post191709
the whole accessory assembly can be unbolted from the block and set to the side leaving everything still hooked to it. To remove the a/c you have to lift the engine up until the bolts are accessible, then remove the four bolts holding the compresser onto the bracket.
Last edited by RedHeartbeat; 12-22-2008 at 10:37 PM.
See my truck data in the "My Garage" section here... http://www.ls1truck.com/forums/my-ga...tml#post191709
Posting Permissions
Reply With Quote