yeah get the mounts from a 5.3, 4.8 and get the frame mounts and the motor mounts.
some of the acc will swap over from the v6...asssuming you already have the bracket on the 6.0....
read here
yeah get the mounts from a 5.3, 4.8 and get the frame mounts and the motor mounts.
some of the acc will swap over from the v6...asssuming you already have the bracket on the 6.0....
read here
I know the flywheel from the 6.0l will not work with my 4l60e but will the flywheel from the 4.3l bolt to the 6.0l?
What year 6.0l? Early models will work with the 4.3L flywheel. Late model won't. Measure how much crankshaft sticks out of the rear cover. If you bolt it to the crank and it wont turn because its against the back of the block, its a newer engine and won't work obviously.
See my truck data in the "My Garage" section here... http://www.ls1truck.com/forums/my-ga...tml#post191709
Guys,
I have my harness and TB swap completed but have a question about the DBC harness. The mechanical TB has two electrical connections but it seems my harness has three? The third connection is an in line 4 plug connector that has one red wire pinned?
mass air flow wire connector?
See my truck data in the "My Garage" section here... http://www.ls1truck.com/forums/my-ga...tml#post191709
Posting Permissions
Reply With Quote