need help wiring!!

[RedHeartbeat]

so should i trace the grey wire from the fuel pump back to the pcm and splice the fuel pump wire into it or whats the best route here?

Does it have a fuel pump relay in the reworked wiring harness? If yes, then it would tie into the grey wire going to the fuel tank. You might call and ask Melissa to ask Jonathan.

[Wtfan18]

Usually the purple wire would tie into the large terminal on the starter solenoid or a bus-bar where all the power wires tie together.

well in the first picture you can see 1 big purple wire and i believe it goes right into the starter relay so thats the wire i was going to use to connect my 5.3 harness' purple wire to.

[Wtfan18]

Does it have a fuel pump relay in the reworked wiring harness? If yes, then it would tie into the grey wire going to the fuel tank. You might call and ask Melissa to ask Jonathan.

yes they made a relay into the harness itself. heres a pic its the one all the way to the right with the red wire coming out of it

[RedHeartbeat]

I updated the post on the purple wire, starter solenoid trigger wire. Small terminal on the starter. Which relay is in the harness, left or right?

[Wtfan18]

I updated the post on the purple wire, starter solenoid trigger wire. Small terminal on the starter. Which relay is in the harness, left or right?

yeah the purple one i will splice into the other purple... or can i not do that and will have to extend it all the way to the terminal on the starter?

all three of those are on my 5.3 harness the one to the left is the fuel pump wire relay. the one in the middle is the fuse box and the one on the right is the ignition relay or w/e.

[RedHeartbeat]

yeah, okay. Tie the wire coming out of the relay to the grey wire coming from the fuel tank.

[Wtfan18]

alright sounds good thanks greg i want this beast running for this weekend!

[knute_gis]

yeah the purple one i will splice into the other purple... or can i not do that and will have to extend it all the way to the terminal on the starter?

From what I understand if you cut the purple wire in half and then tie the new purple wire into the end going into the relay...then hook your factory wire to the starter.

I think this will then go through the clutch pedal safety switch so it wont start unless the clutch pedal is pressed all the way down like factory.

Please tell me if I'm wrong.

[LS1GMCTruck]

From what I understand if you cut the purple wire in half and then tie the new purple wire into the end going into the relay...then hook your factory wire to the starter.

I think this will then go through the clutch pedal safety switch so it wont start unless the clutch pedal is pressed all the way down like factory.

Please tell me if I'm wrong.

This is correct.

[LS1GMCTruck]

yeah, okay. Tie the wire coming out of the relay to the grey wire coming from the fuel tank.

...X2...