hmm i might have to look at a diagram or something i duno what it looks like. im only asking because i need to tap my passenger side head on my 5.3 for the new temp senor unit adapter from S&P and then attach the temp sensor to it correct?
hmm i might have to look at a diagram or something i duno what it looks like. im only asking because i need to tap my passenger side head on my 5.3 for the new temp senor unit adapter from S&P and then attach the temp sensor to it correct?
09 CREWCAB LTZ SILVERADO, 6.2, SIX SPEED, CAI,
if you got a 12mm adapter from S&P you should be able to pull the plug that is screwed into the block on the passenger side head and replace it with the adapter. Don't install it permanently until you put the engine in the truck. You could tap the water pump housing and install the original sensor in it. The right rear of the engine is really crowded for room once its installed in the truck.
See my truck data in the "My Garage" section here... http://www.ls1truck.com/forums/my-ga...tml#post191709
Posting Permissions
Reply With Quote