I need this exact design to put a chevy 6.2 in my truck and clear the steering box.
Right now the steering box is where the PS pump is so I need to relocate it and this design (though I dont need a CF look to it) is perfect.
I cant find where it came from though.
Can anyone help me locate the maker or who makes one just like it?
Thanks
Welcome to the site. What vehicle are you putting the 6.2L engine into that you're have interference?
I've seen that somewhere, maybe I can locate it.
SynisterProducts has something similar to it but I'm sure its more expensive.
Last edited by RedHeartbeat; 02-16-2008 at 08:10 PM.
See my truck data in the "My Garage" section here... http://www.ls1truck.com/forums/my-ga...tml#post191709
its going into a 1997 Land Rover Defender 90 Soft Top.
The steering box sits right where the PS pulley does now.
I "might" be able to use an LS7 system, but this one would give me alot more clearance.
Thanks!
do you still need a power steering pump accessory drive in the setup?
See my truck data in the "My Garage" section here... http://www.ls1truck.com/forums/my-ga...tml#post191709
where did you get the picture?
See my truck data in the "My Garage" section here... http://www.ls1truck.com/forums/my-ga...tml#post191709
how about one of these setups? Not cheap but should work...
Dreamers Rods & Pickups N.W. - Search
See my truck data in the "My Garage" section here... http://www.ls1truck.com/forums/my-ga...tml#post191709
I dont remember where I found that photo, it was about a year ago before I got the engine set in the frame so I wasnt sure if I needed it.
Now I can remember where.
I need PS and alt, and will use the stock a/c mount/pully/tensioner if possible.
That site you mentioned, the only one with PS and alt still wont clear.
The steering box would hit the pulley. I am 90% sure a tensioner in that location like in the one I am trying to find would clear though.
thanks
Looks kinda like the Zoops Posi trak system:
Posting Permissions
Reply With Quote