OKOK. So the drawings i put up in first post say to use 1/4 inch steel...but yours are 3/8 correct? I like a little bit of insurance for "junstincases."Got my ls1 block in the back of the hyundai and taking it to work tomorrow. Got my v-8 cups, i plan on making plates, bolting them to cups, then taking THOSE dimensions and making:

*

So what is the difference in v6 and v8 on-frame motor mounts? If i can get my hands on a set i can make a one-piece motor mount for the v8 and a seperate revison for the v6 equipped obs trucks. In theory, it would keep v6 trucks from taking their front end apart, buying new v8 on-frame mounts, v8 cups, banging cups flat, and then get adapter plates....or am i just wasting time and need to make my steel plates and go about my business?








* (c) 2007