Got heads back today from Indy Cylinder Head.. Check out the flow sheet :



These are basically lightly ported stock 6.0L heads.. I am going to bolt them to the heads to lower the compression ratio a bit.

I also got a bunch of transmission goodies over the last couple of days.. I think everything I need for the transmission build is finally here.



This is the output sensor and sensor ring assembly as the transmission was originally a 4x4 tranny. I wont be re-using the original Tcase where this is normally located. The 2wd trannys have this already:


High Energy Reverse Band and High Friction Front Band:


Forged Clutch Hub, this replaces the stocker thats stamped, should help out if I decide I wanna throw the Juice at it at sometime:


I am soo excited about this project.. I can hardly contain myself.. Its been a long time coming, but I can see a distant light at the end of the tunnel.. I just hope its not the train :wink: