hey guys im reading all over and some people are saying any cam just about will throw a po300 code .is this true.and that the misfire perameters need tro be set higher.im not feeling it alot and i feel it could be the cam.its just alittle shaky in gear at idle,wen it pops the code.i do feel it alittle more with a/c on.like a bad plug.but i could be looking too hard.ya know .some are saying that low idle will cause it.turn up the idle 500 rpm could fix it?it does do it wen the idle comes down.aaaalllleen what do ya think bud?
mods:2004 sierra ext sb,20s ,big brake kit w,hawk pads,air bagged,2006 6.0 lq4 swap,vortec supercharged10psi, air to water intercooled w/ dual electric fans on it ,snow meth injection kit,60lbers, e-fans ,big radiator swap ,cam 218 /222 548/550 comp .hardened prs .1.85 comp roller rockers ,guideplates ,crane double springs,trans 4l65e built .pacesetter l/ts true duals w/x pipe and magnaflows,14 bolt rearend swap ,3.73s,aroemotive fuel pump system w/elec.fuel controller and bypass regulator a/n fittings, taylor 10.5s interceptor gauge,aem w/b a/f ,autometer boost/vac NELSON 93 OCTANE TUNED .
Reply With Quote