i just put the corvette servo in and now it wont shift into 4th. Can someone plz tell me wut i did wrong.
i just put the corvette servo in and now it wont shift into 4th. Can someone plz tell me wut i did wrong.
you put the wiper seal on backwards on the 4th piston. Its directional and should point the open end outwards from the transmission centerline.
See my truck data in the "My Garage" section here... http://www.ls1truck.com/forums/my-ga...tml#post191709
can you b more descriptive because it didnt come with direcrions and i honestly dont kno wut each piece is.
the cover piece, inside of it is an almost flat disk with a groove on the outside diameter of it. Inside that groove you put a plastic oring. That oring has a flap more or less. Its kind of L shaped. The long portion of the leg/flap should be pointing towards the cover piece.
See my truck data in the "My Garage" section here... http://www.ls1truck.com/forums/my-ga...tml#post191709
maybe this will help s-series.org
See my truck data in the "My Garage" section here... http://www.ls1truck.com/forums/my-ga...tml#post191709
thanks but i still dont see wut i did wrong. i cant really do anything until i get a new cover o ring
so correct me if im wrong the last piece to go in before the cover is the piece that i got the o ring wrong on?
that is correct. You can usually stretch the oring through the slot enough that it gets thin enough to pop the cover off without damaging the oring. I stick a small screwdriver in and grab the ring and start stretching it until the cover pops out.
See my truck data in the "My Garage" section here... http://www.ls1truck.com/forums/my-ga...tml#post191709
the more i think bout it i never replaced that o ring because i was just using that piece over?
i pulled it apart.the piece rite behind the cover wit the plastic ring on it had the plastic folded over in a spot. i guess i was rushing.
Posting Permissions
Reply With Quote