does anybody know which shift kit is good to use on a 1999 silverado 5.3liter. I want it to shift hard but not to hard where i might break parts?
does anybody know which shift kit is good to use on a 1999 silverado 5.3liter. I want it to shift hard but not to hard where i might break parts?
http://i32.photobucket.com/albums/d2...y/DSCN5974.jpg
'99 5.3ltr, k&n cold air intake, hedman headers, flowmaster, electronic exhaust cut-out, 4/6drop,
<div class='quotetop'>QUOTE(doubledeezy @ Jan 12 2007, 11:49 AM) [snapback]79420[/snapback]</div>transgo hd2 kitdoes anybody know which shift kit is good to use on a 1999 silverado 5.3liter. I want it to shift hard but not to hard where i might break parts?
[/b]
04 Grand Prix GTP
03 Z71 wanting a Turbo ,Stall, and Tune BAD
THE SURGEON GENERAL SAYS NOTHING ABOUT SMOKIN A FORD
thank u...i'll look into it
http://i32.photobucket.com/albums/d2...y/DSCN5974.jpg
'99 5.3ltr, k&n cold air intake, hedman headers, flowmaster, electronic exhaust cut-out, 4/6drop,
their is some other parts you can buy with the kit. HEY RED !!need some help, cant remember what the parts r called
04 Grand Prix GTP
03 Z71 wanting a Turbo ,Stall, and Tune BAD
THE SURGEON GENERAL SAYS NOTHING ABOUT SMOKIN A FORD
servos would help you out as well
sprayedenali: i like catching, but not fishingOriginally Posted by DamnYankee
lol...I wish you would never paint your truck...I bet it bugs them that much more that a primered up truck just soggied his Wheaties. good job buddy
DBTBSS: bring Tyler... we need someone to make fun of
MidnightRider: your right im gay
DamnYankee: my nana failed
DamnYankee: confused...if it can't keep up to begin with, how can it keep up
mitch cobb racing: ya, allen played with it for a while, HUGE difference
have vette servo already and it works great over stock
04 Grand Prix GTP
03 Z71 wanting a Turbo ,Stall, and Tune BAD
THE SURGEON GENERAL SAYS NOTHING ABOUT SMOKIN A FORD
Depends on how deep you're going into the tranny. Personally I think the Transgo SK kit is plenty for most transmission shift improvements. Get new aluminum pinless accumulators, a billet superior 1-2 and 3-4 servos, a new transgo transmission seperator plate, a couple extra check balls just in case you lose one or two while doing the change over. You could get the vacuum pressure regulator kit too if you want to go all out. A lot of guys buy a longer pin for the 2nd gear band, it goes behind the 1-2 servo, I've never needed one though. Get a new filter and run some good quality trans fluid in it, no synthetics.
See my truck data in the "My Garage" section here... http://www.ls1truck.com/forums/my-ga...tml#post191709
thats what i was lookin for. thanks red, you always know how to help out
04 Grand Prix GTP
03 Z71 wanting a Turbo ,Stall, and Tune BAD
THE SURGEON GENERAL SAYS NOTHING ABOUT SMOKIN A FORD
how long will my tranny last if i put a shift kit in?...i went to a shop and he said it won't last long...is he blowing smoke or is he telling the truck?
http://i32.photobucket.com/albums/d2...y/DSCN5974.jpg
'99 5.3ltr, k&n cold air intake, hedman headers, flowmaster, electronic exhaust cut-out, 4/6drop,
It depends on how bad of condition the transmission is in to start with. It's a little harder on the transmission but so is racing or pulling a trailer.
See my truck data in the "My Garage" section here... http://www.ls1truck.com/forums/my-ga...tml#post191709
Posting Permissions
Reply With Quote
