Why go single when you can have Twins? This is our flip manifold twin kit with the turbo facing forward and tight in the enginebay. We think this is the best looking twin kit out here. The waste gates are routed into the downpipes, with flex joints making it alot easier to bolt up. I would say 95% complete.
Kit comes with
2) MasterPower T70 .63a/r
2) vband clamps
2) 38mm waster gates (cooper gaskets, no blow outs)
2) stainless steel Mid pipe sections with gaskets
2) stainless steel down pipes, drivers side is routed under the truck to the passenger side. and merges into a custom Y.
1) 2.5 x 4 merge pipe. We are using a 4" diesel exhaust on this truck
Custom air to water intercooler. We took 2 singles and cut them apart and rewelded to make 1..Hanging infront of the engine but you could move it somewhere else, just requires more piping and couplers.
1) complete set ofsilicone couplers, clamps and piping.
Things you will need.
3) 2.5 exhaust band clamps.
1) 4.0 exhaust band clamp.
2) air filters / kits
2) oil line kits (turbo have our billet drain fittings attached.
finsih rigid mounting IC.. IC has temp brackets on there right now.
Normally this kit would be around 4200.00 as it sits, but its Christmas time so 3700.00 + freight and I am sure somone has been thinking about doing twins.
Reply With Quote
Originally Posted by RedHeartbeat
