hey guys will this be the Y pipe i need for my 98 5.3 swap? Yall running the long tube pace setters!
whoops heres the link!
eBay Motors: LS1 PaceSetter Off Road Y-Pipe 99-06 Chevy Truck (item 360000257575 end time Dec-05-07 07:17:01 PST)
hey guys will this be the Y pipe i need for my 98 5.3 swap? Yall running the long tube pace setters!
whoops heres the link!
eBay Motors: LS1 PaceSetter Off Road Y-Pipe 99-06 Chevy Truck (item 360000257575 end time Dec-05-07 07:17:01 PST)
Last edited by Wtfan18; 11-30-2007 at 03:28 PM.
09 CREWCAB LTZ SILVERADO, 6.2, SIX SPEED, CAI,
um ... wheres the link?
2009 CHEVROLET 1500 with a MONSTER 4.8 between the frame rails!!
Tuned by LSX Powersports ~ 4.10 ~ JBA Shorties ~ 4" Inlet/Outlet Spintech ~ Airaid Coldair
CST 3.5" Spindles ~ Camburg Upper Control Arms ~ 2.5" CCM ~ FFR Tie Rods
Full Throttle Suspension 3" Lift Blocks ~ Soft 8s wrapped in LT285/70/17 Silent Armors
if you get long tube pacesetters to fit in your 98 you will be the first to accomplish that. There's no room for them to fit on the passenger side. NITROUS is in the process of designing some for manufacture. I have long tubes but they're hand built.
See my truck data in the "My Garage" section here... http://www.ls1truck.com/forums/my-ga...tml#post191709
yeah i had heard nitrous is i guess if he has them done when i need them itll be a good investment other wise just go shorties or midlenght? ne brands that are recommended?Originally Posted by RedHeartbeat
09 CREWCAB LTZ SILVERADO, 6.2, SIX SPEED, CAI,
Fbody stock manifolds for a start and then get the new LTs when he gets them done.
See my truck data in the "My Garage" section here... http://www.ls1truck.com/forums/my-ga...tml#post191709
My right side f-body manifold would not work, it hit the rear upper a-arm frame mount. I had to use a 5.3 truck manifold.
on my 6.0 i sused the stock manifolds and was alittle tight on the driverside but i think my y pipe turned out ok except my welds lol
1998 chevy 1500 with 6.0/4l80e comp cam, tune, exhaust,
Edelbrock Shorty Headers: EDL-65022 - summitracing.com
these are the ones im getting for my 6.0 swap in my 98 chevy truck . they fit and flow nice
i was about to say. run some shorties
2009 CHEVROLET 1500 with a MONSTER 4.8 between the frame rails!!
Tuned by LSX Powersports ~ 4.10 ~ JBA Shorties ~ 4" Inlet/Outlet Spintech ~ Airaid Coldair
CST 3.5" Spindles ~ Camburg Upper Control Arms ~ 2.5" CCM ~ FFR Tie Rods
Full Throttle Suspension 3" Lift Blocks ~ Soft 8s wrapped in LT285/70/17 Silent Armors
nice i have run out of money so. but later on i might inve3st in them
1998 chevy 1500 with 6.0/4l80e comp cam, tune, exhaust,
Posting Permissions
Reply With Quote