I'm installing the 4l80e hd2d kit in my trans. I'm having trouble getting the damn pump off. How does it come off?
I tried using two 7" long bolts that go in place of 2 existing bolt holes then I took a 2x4 cut a hole to slide over the input shaft. Then i drilled some slots for the 7" bolts. The I dea was to crate my own pulling tool but I'm tightening this thing pretty damn tight and the pump isn't budging. I don't want to screw anything up so before I try to tighten it anymore I hope I can get an answer.



Also, for you guys having trouble removing your boost valve:
I drilled a small hole into the top of it then I screwed in a screw and then pulled on the screw to remove it. It seeems not all boost valves will drop out after you remove the snap ring.
Thanks guys