my truck - 01 ext. cab
im doing the 80e swap and have been told that the stock 2-piece driveshaft will still work (assuming i get the right U-joints and all that).
is this true or am i going to have to get another DS?
my truck - 01 ext. cab
im doing the 80e swap and have been told that the stock 2-piece driveshaft will still work (assuming i get the right U-joints and all that).
is this true or am i going to have to get another DS?
01 Silverado
true
See my truck data in the "My Garage" section here... http://www.ls1truck.com/forums/my-ga...tml#post191709
so theres enough play in the stock one and itll all work fine?!?
i cant imagine itll work, but if you say it will then i guess it will
01 Silverado
My word is golden.
See my truck data in the "My Garage" section here... http://www.ls1truck.com/forums/my-ga...tml#post191709
i sure hope so... i dont want to have to buy a custom DS!!!!
01 Silverado
Yeah u can use the stock drive shaft but u have to swap the slip yoke for a short tailshaft turbo 400 yoke and then u have to run a hybrid u joint to go from a 1350 to a 3r
Junkyard 5.3 milled heads 200 shot, built 4l80e with circle D 4000 multi disc converter
EPS cam 23x/23x 600/603 112lsa
KP 6 link bagged with Accuair E-Level
http://www.nitrousexpress.com/
If you have any more questions you can pm me I just got done with my swap
Junkyard 5.3 milled heads 200 shot, built 4l80e with circle D 4000 multi disc converter
EPS cam 23x/23x 600/603 112lsa
KP 6 link bagged with Accuair E-Level
http://www.nitrousexpress.com/
cool, thanks Trey
01 Silverado
Posting Permissions
Reply With Quote