The Dorman/Russell/Jeg's aluminum fittings that snap on the Vette filter...how do you get them off? They have plastic lock thingy's that release them somehow? Can't get them off. Thanks
The Dorman/Russell/Jeg's aluminum fittings that snap on the Vette filter...how do you get them off? They have plastic lock thingy's that release them somehow? Can't get them off. Thanks
they make a fuel rail disconnect tool you slide it in, push the tool inside the fitting, it releases the locks
2008 GMC CCSB 6.2/6L80e swap
Gen IV 5.3/60e swap 1994 ecsb W/T
NAPA tool #775-9081
2003 GMC K1500 ECSB running an Iron 383 Stroker ......
Thanks guys...But I should have been a bit more clear. The fuel fittings I mean, are the billet aluminum versions, that have a white plastic piece that locks them onto the tube. Its probably something simple, but I can't seem to figure out how to get the white plastic dodad to release these fittings off the tube.
if they're like mine were you compress the fitting as far as you can towards the filter and then squeeze the plastic tabs and slip the fitting off.
See my truck data in the "My Garage" section here... http://www.ls1truck.com/forums/my-ga...tml#post191709
O.K., Red. You push the fitting farther on, then pinch the white plastic tabs. Gotcha. Thanx.
Posting Permissions
Reply With Quote
