I want to have a nice lope but dont want to over cam it. Its for a 2001 stock 4.8, I already bought a stock LS1 cam off ebay for $25 I was goin to have it custom grinded to 220/220 stock 4.8 lift and 112LSA. I want to keep my lift stock so I can mill the heads .030 and raise my compression from 9.5/1 to 10.9/1. Im thinking a 3000 stall should do fine. Im open to any suggestions because I am by far not an engine builder. Also any idea on how much a cam install is, I was thinking of going to Futral Motorsports since their right around the corner for me.