Engine | Transmission | Drive Axle | Chassis | Fuel
anyone herd anything about this product? VR-4
Well, as some know I am in the process of swapping my 4.3/5 speed for a 5.3/4l60e in my 1991 Chevrolet 1500. As of now I have a huge hole in my...
I was wondering if you guys had any tips for putting in my cam. I plan on taking off my front end to take out, and install the new one. Also i was...
I pulled a Core motor apart ... going to put rings and bearings in it.. and the front main Cap.. its marked number one is on the Wrong side... ...
If i install a 2600 stall Yank converter how is this going to affect my gas mileage?
ok, i have a 2003 silverado Z71 with a 5.3 in it. i want more power, just becuase i have a sudden urge to just mod the hell of out my truck lol. but...
Has anyone had experience with swapping in an LS7 cam to an LS1 or 5.3? What are the drinving characteristics like?
4 times today while trying to start my truck i had NO oil pressure. once i even checked it with the Interceptor and that read 1. the last time i had...
has anyone heard about the heads on the 07' and up trucks? i heard they flow over 300 stock. is that true?
i have a 91 chevy 1/5 ton with the 10 bolt rear. i have the gear, complete bearing kit and everything else i need to swap the gears because a buddy...
right now the truck has true duals, with pacesetter LT's, into old flowmasters, with 2.5" pipe. sounds very good, imo, even with the small,...
I am currently in the middle of installing my FLT trans and converter. The converter is a PI vig 2600 stall. I bought it used from a member off of...
well, first, i will say that the engine and PCM/harness, came from seperate cars. both out of 2000 camaro's, but different cars. the engine has a...
does anyont have some comp 1.7 roller rockers that fit under the stock valve covers cause i mocked them up and they don't seem to fit...do you need...
Yeah I jst bought my dream truck an 87 silverado and was thinking about swaping the weak 305 for a little more umph. But was wondering where i could...
DUR @ .050" 210*/218* LIFT .551 / .551 OVERLAP 52* LSA 112* :cool:
I got a chance to buy a set LS1 heads off of a 97 Vette, the heads are stock and have around 60k on them. Is it worth it for 200 bucks, or will it...
:bs: 6 months ago I had a low fuel pressure problem.... 48psi @idle and 56ish with no Vac to the Reg... Installed a 255 pump and Hotwire kit......
Cam shaft install. Comp Cam 212 216 LS114 .557 .561 lift , CC Push Rods, CC 1.75 Roller Rockers, Z06 valve springs. 1. Didn't have any trouble...
T56 transmission from 1999 c5 Corvette t56 transmission from a 1999 c5 corvette 550$ Thats a smokin deal right? I was wondering if you guys new...
Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules