Forum: Powertrain

what do you reccomend using the towing or street strip ??? with the stufff i have done i can already chirp 2nd and it shifts prety hard will the...

Im planning on going with the McGaughys 2/3 Deluxe drop kit but I would like it to handle as best as possible and give me as much traction I can...

I have been investigating the '05 elect fan set up for a while. Even purchased the fans and they are in the garage. Proved to myself that the new...

Alright, is this correct? http://www.jegs.com/cgi-bin/ncommerce3/Pro...530&prmenbr=361 It has Silverado 4.8/5.3 listed there. Is there some way to...

Yes I just wanted to say this is a wonderful site and glad i found it. I am going to be installing a servo on my transmission i have a 460le i would...

Did my cooler install the same day as the servos, luckily it went well. Before I started I got some more hose and lock nuts for the bolts. Pretty...

anyone know the specs for my rear end? it has 3.73 gears and is stock i wanna get a posi off ebay but i wanag get the right one andf i figured it...

changin my plugs i have plat 4s now but ppl have been sayin switch to ngk or iridium delcos? any input on this

Obviously fully dropping the transmisson and removing it is one way to install a converter. In fact, actually getting the trans out seems to be the...

I'm looking for a semi floating 14 bolt or a way to make the 14 bolt full floater rear end a 6 lug. Anyone know what vehicle the SFA 14 bolts are...

I just got done swapping the thermostat out in my 05 silverado I put a 160 slp unit in Then took it out for test spin temp still reads right about...

Well, yersterday I installed the TransGo shift kit. I did want a firm 1-2 shift but with any acceleration at all and the tires bark. It's too...

For the tranny fluid supply line going into the cooler, does anyone know if the short rubber hose between the steel tubes is std 3/8" ID? It looks...

I received my set of Stage 2(CNC), 6.0L, West Coast Racing Cylinder Heads (WCCH) Today! These things are like jewelry, they are beautiful! Let me...

I replaced the two 3.5"(approx) idler pulleys with 4" idler pulleys for two reasons. 1. To get more blower pulley wrap ( especially if I pulley...

Well folks, Today i got my autolite 103 plugs in and everything seems to be working well, swapped the original AC Delco's out for them. They were...

I am about to pull my servo out of my truck, again. This time I'll be installing the longer servo pin. My question is this: When reinstalling the...

What kind of upper control arm bolts are in your truck? I started with a '91 1500 2wd, and it just had standard bolts in the slotted holes. I...

I traded my 93 2wd for a 95 4wd. well i took it out playing in the mud last night and i couldnt get the 4wd to engage. My clutch is shot could that...

any body got one. i need one really bad. mine went ti shit today. i need a complete good one or any parts for one some one might have. please help...