Forum: Powertrain

So I've been looking on the internet and the LSD I bought used is like this: On ebay So this isn't the same as a G80... I hope because I'm...

can you use these on a truck manifold i know that the truck fuel rails are different than the f body's but want to know if i can use this

I have the electric throttle body and was wondering if the same rules go for porting them as for the cable tb? I'm going off of TXSILVERADO car...

Does anyone know if these will fit my 04 2WD VHO? It is lowered with 3" drop springs in the rear, but I don't think that will matter. Lakewood...

Anyone know the length of these two, in 2wd version? I'm figuring out my driveshaft length and it's very critical I get it exact. thanks in...

so im looking at getting an auburn lsd... what one do i need to get??? Aftermarket - Products - Differentials - Pro Series am i looking in...

I'm looking at this tranny 1997 TRANS AM LT1 T56 TRANS ((PARTING OUT)) The guy says the car and Tranny have 113k miles on it. Anything i should...

T56 transmission from 1999 c5 Corvette t56 transmission from a 1999 c5 corvette 550$ Thats a smokin deal right? I was wondering if you guys new...

Cam shaft install. Comp Cam 212 216 LS114 .557 .561 lift , CC Push Rods, CC 1.75 Roller Rockers, Z06 valve springs. 1. Didn't have any trouble...

I got a chance to buy a set LS1 heads off of a 97 Vette, the heads are stock and have around 60k on them. Is it worth it for 200 bucks, or will it...

DUR @ .050" 210*/218* LIFT .551 / .551 OVERLAP 52* LSA 112* :cool:

Yeah I jst bought my dream truck an 87 silverado and was thinking about swaping the weak 305 for a little more umph. But was wondering where i could...

does anyont have some comp 1.7 roller rockers that fit under the stock valve covers cause i mocked them up and they don't seem to fit...do you need...

well, first, i will say that the engine and PCM/harness, came from seperate cars. both out of 2000 camaro's, but different cars. the engine has a...

I am currently in the middle of installing my FLT trans and converter. The converter is a PI vig 2600 stall. I bought it used from a member off of...

right now the truck has true duals, with pacesetter LT's, into old flowmasters, with 2.5" pipe. sounds very good, imo, even with the small,...

i have a 91 chevy 1/5 ton with the 10 bolt rear. i have the gear, complete bearing kit and everything else i need to swap the gears because a buddy...