Forum: Powertrain

I was wondering if its possible to swap some arp rod bolts into a motor, without pulling the motor, and just removing the oil pan ? I'll be doing...

I ran my truck on the strip stock with cold air and muffler delete ran 15.9 I was wondering how much would a stall and gears help and which is the...

I've been doing some reading on the 4l65e tranny in my SS and I read that they're rated for about 400 ft/lbs of torque. I've got Gibson shorties,...

My wife's tahoe is the most gutless V-8 I have ever had other than my high school hooptie 77 cutlass. This thing just falls on its face after 1st...

My 04 has developed a clanking noise upon take off every so often, It usely only does it when the truck is first started and driven a few feet....

3 hours of searching and I just cant seem to get an answer anywhere. I am in the process of upgrading my fuel pump for my LQ4 conversion. In my 95...

Hey guys, I've been tossing around the idea of swapping to a 80E before I start doing some more serious motor work. Basically wanna have a...

Well after hitting a curb at 50 mph due to a dumb lady that almost T-boned me and wife I now have a bent left rear axle tube and am wanting to get...

http://kansascity.craigslist.org/pts/3129639525.html Seems a little on the high side... but I think it looks to be a good candidate for my 93 scsb...

Does it matter the year? I found a good deal on Craigslist but the trans and transfer case is from a 95.. will I have problems putting in my 2010 or...

]Is it worth the $ to get the diff. cover with the bearing cap support made into them. Like this, ...

Alright well since I'm a total idiot and can't get the transmission wired up right, I am interested in doing a full manual swap to the valve body....

Ok i am really torn as to what i should do with the cam in my 5.3 swap. The truck is meant to be a nice highway cruiser get decent mileage but still...

does anyone know the lug pattern for the 1948 3/4 ton chevy truck? its 8 lug i really want to put some wheels on it and dont know the lug pattern.

does anyone know what the stock stall on a 96 truck 4l60e & an 02 camaro 4l60e? i'm just wondering if i should have swapped out the torque...

I have a 1999 ecsb 4x4 with 4.8 and 3.73 gears, it has 210,000 miles on it and i just drove it from TN. to NY. and back, 1150 miles each way and...

Turns out one of the fittings on the firewall for the heater core hose is leaking. I have no idea how to pull those fittings off, nor do I have any...

im in the process of a 6.0/80e swap in my 1500 silverado.. i have a 2500hd driveshaft that is the right length but on the gear end the u joint is...

when i fired up the fuel pump today i had fuel seeping out of the pass side fuel rail crossover pipe to the fuel rail, i guess the oring is bad...