Engine | Transmission | Drive Axle | Chassis | Fuel
about to pull it on a 100 dry shot kinda pieced together over the week.... SCHWEET!! need call allen for a little timing reduction and fuel...
I was wondering if someone could state the differences between a cam for a naturally aspirated setup and a cam for a forced induction setup. As...
... just wondering how easy it is to replace and more importantly purge after it's all put back together. Anybody ever replaced one on a newer GM...
Between my vette servo and hd-2 kit, the 1-2 shift knocks your teeth out at WOT, even with NO spacers installed. So I pulled the pan to set the...
ok heres the deal .ive had a stock trans in my truck all winter while i bought all the parts from flt 4 my new built tranny.my tranny isnt holding in...
Im trying to put my helix back on with the bbk 80mm tb, i got longer bolts @ a machine shop that was the same thred size as the one that came with...
Does anyone knows the LS1 rod clearances once installed in the crankshaft?
Now that I have the lift on there, I feel like I am blinding people.... I brought it to the dealership for maintance and asked them to adjust the...
What affect will this have on my rpms on the highway and around town. And how bad will it affect my gas milage. The truck will have 20's on it
I was wondering how to fix the threads of a bolt like the threads on the steering shaft that holds the wheel on. long story short i'm an idiot and...
What Cam Should I Run In My 6.0? I Got Long Tube Headers, Ls6 Intake Ported Throttle Body, Flowmasters. Oh Yeah I Got The Stock Lq9 Heads What Do I...
Just got done putting my dynatechs on my truck today, does everyone who run longtubes notice more "tingy" noise right under the truck? also havent...
have any of you ever used the E3 plugs or the MPG+ wires from granatelli?
Is there such a option/crank? If there was, would it be worth it?
During my drive to work today my check engine light came on. I installed a 160* t-stat two days ago. Has anyone had their check engine light come on...
Does anyone know what a stock 5.3L head flows? Is there a chart out there somewhere that specs all this info?
Will The Stock Lq9 Oil Pan Work In My 2000 Chevy Truck???
something down there is going clink when you take up the slack from a stop light. shifts great other than that. its a performabuilt 9.5" 3600 2.1...
I have the original 4.8 out of my silverado.....I believe the heads are an 862 casting......are these junk like I been told......on mortec, it says...
dose any one make any aftermarket that will fit the gen III truck intake
Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules
