Forum: Powertrain

Well i replaced my fuel pump last week thinking that would help my problem with my truck. With the fuel pressure messing up ect. I have not been...

How do you put in a vette servo? What does this do to your transmission? I see everyone has one, just curious. I was just in craigslist and a guy is...

Accidently threw the instructions away while cleaning my garage....at least I think I did cause i cant find them. Called Transgo several...

I made some changes to my setup and the air box normally pulls air from both sides but i made a fibreglass bottom for it.Intake temps tonite were 6...

Hey guys, I changed out my cam today to my old stock ls6 cam after i got it back from specing. Just because i changed out my cam so many times and...

It seems ever since I installed the 4.56 yrs ago I've had a driveline vibration. With my old 383/700r4 and driveshaft it was always bad around...

where the F do I buy one. Found some timken bearings, but not in a "kit" with seals and everything. There is some other brand universal kit, but I...

Okay, on my way home today and apparently the A/C belt shredded, which in turn threw the main belt. Couldn't pull over for a mile or so...by then...

i cannot figure out why this code will not go away. i have an 02 2500hd with the 6.0. it has a comp cam (p/n 54-451-11), comp cam programmer, 3" dual...

Ok guys heres my problem. My truck has pretty much been sitting since spring time, though I've been working on it a bit. Well I got my Gto and I...

i was wondering if anyone knew which cam would be best for my setup. i have all of the mods listed below. i saw the cam in the 100 hp and wasn't sure...

Since my truck was broken into and the pass. door handle destroyed, its in need of a replacement. I can find factory replacements that have been...

I just bought a Servo "set" from Ebay(item#330273138451) with a Corvette Servo(with extra heavy duty accumulator spring) and Sonnax Billet 4th gear...

does anyone know of a place to get taller valve covers for an lq9 or even spacers to make high lift roller rockers

Hey all, Its been a while, after loseing interest in my truck I let it sit for a while, Now I'm beginning to finsh it up. My truck had the...

Intermittent sputtering above 1500 rpm. Only seems to happen when it's been running for some time, and mostly when pulling a load or climbing. Think...

These are the choices I've come up with. 214/218 .600/.598 115 lsa on 110 icl 216/220 .600/.598 115 lsa on 110 icl 220/224 .600/.598 114 lsa on...

Full Size Pictures: LS1 Fan Installation LS1 Fan Install Thought since I always ask so many questions that I would throw together a little...

Any help? Its AWD and it has the automatic ride level in the rear. I only want a 2" drop at most.