Forum: Powertrain

bro!!! http://www.ls1truck.com/forums/parts-wanted/20561-wanted-6-0l-short-long-block.html whats up with dat!!

Im putting a LT1 into my Chevy K5 the water pump has the thermostat housing facing the lower port on the rad and the pump port facing the upper rad. ...

I am having problems with my heater not changing locations (ie; defroster, dash and floor), it basically stays on the defroster but it also moves...

ok.. ive got a 94 1500. ran good during the spring summer and fall. but when winter hit.. i noticed that it started missin REALLY bad when it got...

QA1's or rancho's for the rear on a 4 inch drop, need links part numbers, anything that would help on getting these. the truck is a 99...

i was wondering if anybody makes a solid motor mounts for an 03 chevy truck or am i going to have to fab some up myself

Just an FYI that I just found out the hard way. I know plenty of us like to have big rims (20" +) on our trucks but it turns out that those big...

My 2001 Z71 has had a problem that I have had a hard time pin-pointing. When going from a stop to giving it gas to go it has this almost squeek of...

I keep hearing a gurgling noise coming from somewhere behind the radio. On a previous thread Gas Guzzler told someone it was a heater core. How can I...

Recently the trucks oil pressure has been right around 20 unless im on the interstate or accelerating hard. I figured the oil was alittle low so i...

Im going to try not to make this very confusing..... Lately it seems like my truck goes into fuel cut for a send right before it shifts into...

Just went to fire the truck up and she almost didnt go. Turned right over and sounded as she normally does, so I let go of the key and it died. I...

After one day with the new tranny work and stall in Im driving. See my friend. Stop talk with him. Show him the new rims. As I pull off I give it...

I asked a couple months back about a cam and I bought the lingenfelter gt2-3 cam. I was wondering how well the heads would work cause the site says...

So anyone got any suggestions on suspension and where to look. I got an 82 s10 and i want to make it handle as well as my bmw LOL TRY to. I looked at...

OK, I was cleaning the servo and dropped one of the pieces and basically lost track of the assembly order. Here are a couple of pictures of how it...

The power is majorly different now. It pulls much much harder then it ever thought of before. I also had a shift kit,servos, beast sun shell... etc...

Just finished my cam swap, and I'm ready to put coolant back in this thing, just wondering exactly how though? My guess is since it's a pressurized...

Tonight while starting on changing my valvesprings, I started turning the bolt to compress the spring and what I thought was threading in must have...