Forum: Powertrain

I'm planning on installing my cal-tracs next weekend, and I was wondering if anyone who has them put the front eye bushings in without taking the...

is anyone selling a posi gear carrier, kinda cheap...i need a 10 bolt 8.6 and i need pics of it , o and it needs to work with 4.10's would have...

Thinking of installing a shift kit in my truck.What are the advantages,disadvantages of a shift kit.I already have the Billet Servo's...

have a 01 chevy 5.3 wanting to put cat back exhaust...i've been looking at magnaflow and flowmaster, i want something that sounds good but not to...

what do people mean when the say there truck is debagged

HOW DO YOU TAKE OFF THE COVER AROUND THE STEERING WHEEL GOING TO REPLACE THE TURN SIGNAL SWITCH:thanks:

can i use a newer z06 cam? a friend of mine hasa few used ones at his shop. can i put one in my 5.3

so when i did my 4.3 -> 5.3 swap, i bought a stock FSC V8 intake tube from the junk yard. i didn't realize until i went to put the engine together...

I need a torsion bar crossmember baddd.. mine has stress cracks on both sides around the bolts. Anybody know where i can find one? i've searched...

G3 XFI 261 HR15 COMP Cams® - Cam Details I am thinking about using this cam in my LM7 383 build. Anyone used this cam or have experience with it?...

Well the truck's been down for awhile due to a cracked flexplate. I pulled the trans out today and found that three ears (bolt holes) on the bell...

I'm installing my Headers and ory pipe this weekend. I was wondering if that would be something that effects my air fuel ratio

This past monday my tranny went up into pieces..im having it rebuild and i was thinking how will a 3000 stall work on my truck since i dont have a...

can someone post some pics on installing a corvette servo, start to finish

Ok after much searching and following links, am I correct to understand that early and late models are the same execpt for some internal parts, which...

Alright I no this guy with a stock ls3 cam, my question is will cam work in my truck and would this be a good cam for my setup

Truck has been throwing the random missfire code here lately. I've done had problems and put on new plug wires off an NNBS. Solved the prob. What all...

where is a good place to get a good shift kit for a 4l60e, and whats a servo?

im looking to put some light weight 15's on my 04 rcsb. Is that a possibility or will i have to go 16's?