Forum: V8 Conversions

when you swapped out your old motor and put in a 6.0,what was your mpg. i have a complete lq4 and i am anticipating the swap. due to the fact that...

ok i got an 04 that i just got done swapping the weak ass v6 for a 5.3 but i cant figure out how to mount the new pedal since theres no studs and the...

Ok I am looking for some info for my dad. He has an 02 shortbed 5 speed and is looking to put a 6.0 in it and was wanting to know what all he is...

i just bought an 86 S-10. my plan is to put the 305 i have laying around in it right now. eventually i will have a 5.3 in it. has any one done a v8...

Hi, I put a 97 Vortech 5.7 into my 98 Chevy 1500 2WD. I used the wiring harness and the computer from the 97 truck. My truck runs ok, but the...

i need some help!!! Pics would be nice, if any, of what wires i need to splice into on the old engine wiring harness to get the stock cluster and...

I have a 92 that i'm putting a 6.0 in and was wondering what everyone was doing with A/C compressor, either cutting the frame or moving the...

What all is involved in swapping and i4 colorado engine with lets say a 5.3? can i use the stock 5 speed?

where can i find a new 7.0L block 427 i want to build one and drop it in my new 2009 gmc single cab but cant find the blocks?

My v6 sucks but not replacing it cause im gonna go to the track or race. Just cause my v6 is getting weaker as i type this. Dont want to spend money...

After completing my 4.3 to 6.0 swap, I got to looking at my rearend gears. I found out they were 3.08 gears. Probably not the best for what I'm...

im about to buy a used 01 6.0 miles xxx,xxx.... what should i do to make sure it wont break down or leak shoud i change all the gaskets?

im about to get one with low miles and just need info to see if it fits or if any one has done it?

what dose everyone think about a 240sx s13 with a l33 and t56 swap anyone aprove disaprove think its a wast of time and money give me some input ...

got 06 chevy sbrc 1500, 5.3L, wanna put a 08 6.0 and 6speed trans in it. I have all stock parts with both motors. im told i can do this and it wud...

i have a 99 rcsb that i have been grudge racing for a few years and the 5.3 has had all she is going to take. i have noticed severe power loss, and...

well i was going about 90 and i got off the free way and the truck kept turning off on me then it just started to knock loud all of a sudden i took...

I Swaped Out My Engines Last Winter And It Hasnt Gone Passed 3 1/2 Only Sometimes It Does And Gives Me The Performance I Need And I Wanted To Know...

I am installing a 2007 truck 5.3 into my 1948 Chevy pickup. The original 5.3 cast iron exhaust manifolds did not work out, dumped on top of frame...

I have a 93 yukon and i am looking into putting some vortec heads on it since the general consensus is that my stock heads suck. im wondering if i...