Forum: Pics/Videos

Stock and boring Parts! After, 3 inch RC lift spindles and NNBS stock blocks.

Here is a video I made of our test session. We ran 176 miles with no problems. Hope you enjoy it.

this stupid video is painful to watch http://www.lsxtv.com/news/video-camaro-zl1-fail-at-the-drag-strip/

Click here to go to the album

Im thinkin about putting a 4 link with coil overs in my truck this winter and id like to get some ideas so if you guys could post up photos of your...

Well I'm Liking my tune a lot thanks nelson for a bad ass tune well here's a vid of my truck killing a Yukon 5.3 Tuned with bolt ons and gears! ...

BIG Thanks for hooking her up!!feels good to drive it once again,this time ill actually try to put miles on it. 80mph roll burnouts on 4lbs :LOL:...

Direct injection First Peek at the Gen-V V8 From GM! - LSXTV

i haven't been on here in a while ,I figured i share my new project . It's not a work truck, but if i have to i will load up the bed so it can serve...

Not the best pics but they are from my phone.

Well I went out and bought me a new toy..

I have been grooming the truck to be competitive in more than just straight line lately. I plan on competing in the truck throwdown and some other...

This vid will be posted in my build thread, as well, but figured it would get more traffic here. New vid from last night. Sorry about the foggy...

Well did a quick wetsand to one of the doors today and laid on three coats of clear! Im really diggin this look!

We just finished up some testing of our shark nozzle direct port with our DF5 valves and lightning 250 solenoids. The results were that we were able...

Welp, picked up a 69 C10 RCSB off a guy from craigslist. He was the second owner and drove it everyday until 91. Said the cab was so rusted it...

The end all 5th gen. These guys are on top of their field. found this on another forum http://www.youtube.com/watch?v=TiTHRc2XKIE&feature=colike