Forum: LSX Truck Conversions

hello guys thanks for all the help so far i want to purchase a larger mass air meter whats the largest one i can get for my truck i have the 5 pim...

i bought a 6.0 off ebay for $100 its a complet block minus the heads it says it had a slight knock when it was pulled but its still running good i...

Hey guys, just got a wrecked 2wd 04 2500hd from my work for a pretty good deal. Plan is to rebuild the trans, leave the engine how it is for now...

Just curious what yall are doing with your A/C, I have Old Air products ( like Vintage Air) in my 65, I have a sanden 508 compressor with a vbelt...

On a 92 k1500 what water temp sending unit is used for the gauge? The one on the side of the block or the one next to the t-stat housing? If you...

I have done a search and seen that many say the internal harness is different. I have a 4l60e tranny out of a 96 caprice that had an lt1 behind it....

i have a 99 silverado 4x4 has 210,000 on it how hard would it be do swap a 6.0 in it want to swap 6.0,4l80e can i use my headers that...

i have just swapped a 2000 5.3 into a 1992 chevy what cold air intake are yall using?

I read the swap article and saw no mention of tach issues and maybe its just me. I am using a 2004 LQ4 which has the blue/green plugs instead of the...

hello, first post here.i hope it's in the right place,and i don't offend anyone.after searching the web this site has come up a few times.this...

i been thinkin about this latley. they had a normal motor but trans was little differnt to make it fwd. the trans was basically a 350/200r4 trans....

Hello, I put 5.3 in a 71 chevy truck. Looking for advice on mufflers. Flowmasters are too loud and I have Dynomax on another truck, but still too...

does anyone kno where i can find motor mounts to swap a 93/5.7 with an 06/6.0? an what is the best/ cost friendly swap harness for this? thanks in...

Got my old job back. So I'm goin to show some love to my '85. It was my dd through high school and college. Figured I'd pay it back. I have some...

This may be going into my LS1 Swap project. It is local and only $250. I will be running a circle d 278mm stall ans 8.1 injectors. cam specs :...

Just picked up a 2006 5.3 with 24000 miles on it for 750.00 which I thought was a killer deal. I was just wondering what everyone on here is doing...

I have been slowly working on my Nissan Hardbody with plans to do a 370. My daily driver is a '04 v-6 rcsb. Lately the lack of power has been...

Getting a 2001 LS1 with a T56 on it. Any issue with is working on a 2004 LQ9? Going to use the intake etc off of the LS1 since it's actually an...

behind a 6.0 in a motor coversion? everyone keeps telin me imma need a controller or something sayin my harness wont work(stock 6.0 escalde...

Here's the final product. Stock 4.3L was replaced with a stock 5.3L. We used the stock trans and fan clutch/rad/shroud setup. The conversion...