+ Post New Thread
Page 93 of 209 FirstFirst ... 43 83 91 92 93 94 95 103 143 193 ... LastLast
Threads 1841 to 1860 of 4169

Forum: LSX Truck Conversions

All LS Based Conversions

  1. Completed 5.3/4l80e swap - Pics and Vids

    Got my 1991 Chevy C1500 RCSB on the road and driving great. This truck is going through a transformation/restoration and this was the first step....

    Started by flattopwill‎, 04-26-2010 01:19 PM
    • Replies: 28
    • Views: 17,269
    05-10-2010, 05:17 PM Go to last post
  2. 350 vortec for ls1

    Can anyone tell me what all i need to do to swap my 350 vortec for a ls1 out of a 1998 camaro i have the wiring harness and the computer

    Started by chevymudder‎, 05-09-2010 12:14 PM
    • Replies: 3
    • Views: 2,358
    05-10-2010, 03:49 PM Go to last post
  3. Cylinder Head Information (GM)

    Might be a repost, but here. GM Head Guide Casting Number 241 Head: 1997+ LS1 5.7 Litre Passenger Car Material: Aluminimum Part Number:

    Started by tanz45‎, 04-20-2010 10:15 AM
    • Replies: 10
    • Views: 11,790
    05-09-2010, 11:55 PM Go to last post
  4. Another '79 6.0 Conversion

    Greetings, Just found this site. Lots of good stuff here so I'll try not to ask the same questions over again. I'm thinking about a 6.0 swap on...

    Started by farmall400‎, 05-07-2010 07:48 PM
    • Replies: 0
    • Views: 1,527
    05-07-2010, 07:48 PM Go to last post
  5. dbw to dbc bracket needed!

    Howdy people, I am working on getting parts together for a lq9/4l60e swap into a 69 c-10. The motor came with a drive by wire tb and a cable tb...

    Started by dyrt‎, 12-18-2009 09:09 AM
    • Replies: 7
    • Views: 3,660
    05-05-2010, 05:31 PM Go to last post
  6. New to the swap tech...03 4x4... 5.3 to 8.1 questions

    Hello, My chevy is nearing its end I'm afraid and its time to look into another motor. Since most motors are about a grand used I might as well...

    Started by robertjegan‎, 05-04-2010 03:31 PM
    • Replies: 3
    • Views: 2,084
    05-04-2010, 05:06 PM Go to last post
  7. 6.0 lq9 into a 84 chevy SWB

    whats up everyone i know i havent posted in forever but finally got me a motor and tranny. got a motor out of a 05 escalade(6.0 lq9) with the...

    Started by JustN87‎, 01-25-2010 07:53 PM
    • Replies: 12
    • Views: 8,241
    05-02-2010, 11:40 PM Go to last post
  8. 5.3L conversion in an '87 TBI?

    Hi all, new here. I was directed here by a member over at Fullsizechevy. I was asking around over there about GM's most fuel efficient late model V-8...

    Started by BennyLava‎, 04-28-2010 12:12 AM
    • Replies: 24
    • Views: 19,854
    05-01-2010, 12:00 AM Go to last post
  9. running at last

    now shes throwing a p0101 code maf and cant seem to figure it out but atleast its running just needs a tune

    Started by fasterwhenIpush‎, 04-30-2010 07:27 PM
    • Replies: 0
    • Views: 1,336
    04-30-2010, 07:27 PM Go to last post
  10. stuck on reduced engine power

    truck finally started and ran fine i took it and put some gas in it and on the way home it went into reduced engine power any ideas

    Started by fasterwhenIpush‎, 04-27-2010 09:49 PM
    • Replies: 4
    • Views: 2,317
    04-30-2010, 06:51 PM Go to last post
  11. And it Starts...................

    The Project has officially begun. Only after hours and hours of scrolling, reading and printing tons of stuff. Here are the first pics of the...

    Started by Z-Rod‎, 04-29-2010 07:46 PM
    • Replies: 4
    • Views: 2,166
    04-30-2010, 10:22 AM Go to last post
  12. reduced engine power

    unplugged the battery for 30 minutes and still in reduced power mode any ideas

    Started by fasterwhenIpush‎, 04-28-2010 07:59 PM
    • Replies: 2
    • Views: 1,702
    04-28-2010, 08:16 PM Go to last post
  13. 88-98 LS1 front Coil Springs?

    I installed the LS1 T56 into the truck and the front end sits way too high. I have 2" drop spindles and Moog 648 springs. When I sit on the rad...

    Started by 88stepside‎, 04-27-2010 09:51 PM
    • Replies: 5
    • Views: 3,570
    04-28-2010, 06:27 PM Go to last post
  14. Gasket help needed

    I am getting closer to doing my swap. I need a little help comimg up with a list of gaskes I will need. All I have is the long block so I will need...

    Started by Blue01‎, 04-27-2010 11:44 PM
    • Replies: 0
    • Views: 1,515
    04-27-2010, 11:44 PM Go to last post
  15. 04 Tahoe 5.3 to 6.0 Engine Swap

    Hey guys, I'm new to the forum. I have been reading several articles on the forums and had a new questions. I would like to do a 5.3 to 6.0 LQ4...

    Started by DMC10140‎, 04-23-2010 04:33 PM
    • Replies: 6
    • Views: 8,313
    04-26-2010, 04:12 PM Go to last post
  16. Lingenfelter TRG-001

    Does anyone know anyone who is using this converter module? This would be the easiest for my swap. I can not find any good info on it and if it lasts.

    Started by Jermoslin‎, 04-25-2010 11:17 PM
    • Replies: 1
    • Views: 3,542
    04-26-2010, 04:19 AM Go to last post
  17. awd to 2wd conversion ?

    hey guys i have an 01 c3 denali awd i want to convert it to 2wd drive for the summer for some fun can it be done and what do i need ? thanks

    Started by Quail48‎, 04-24-2010 09:25 PM
    • Replies: 3
    • Views: 1,822
    04-25-2010, 01:10 PM Go to last post
  18. LS6 intake

    I am looking a buying a LS6 intake for my 5.3L, if I buy the intake what other stuff do I need to buy? my main question is weather the throttle body...

    Started by buff‎, 04-24-2010 06:01 PM
    • Replies: 2
    • Views: 1,650
    04-24-2010, 11:18 PM Go to last post
  19. Can you swap L-92 heads and intake to a 2005 seria

    Will the L-92. Setup work on a 2005 sierra 5.3

    Started by petey62782‎, 04-24-2010 06:17 PM
    • Replies: 2
    • Views: 1,704
    04-24-2010, 09:55 PM Go to last post
  20. Engine wont start

    I've got a 4.8l engine in my project truck. I just finished wiring it back up Friday and it fired right up. I started it for about 30 seconds maybe 4...

    Started by jcfreeman0‎, 04-20-2010 12:26 AM
    • Replies: 10
    • Views: 5,119
    04-23-2010, 04:42 AM Go to last post

+ Post New Thread

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts