Forum: LSX Truck Conversions

I'm considering doing a 5.3 swap on my 2000 silverado ecsb with a 4.3 and a 5 speed. I've found an engine that's somewhat local but it's out of a...

Can I remove the round coffee can evap canister under the hood or remove it and plug off the line going to the tank?

Anyone have trouble with the throttle sticking? Its not the cable, ill stop and open the hood and theres slack on my obs just finished the swap

My driveshaft fits, but its clearance in the transfercase is too close for comfort. When I am in the dunes I dont want it to preload and jam itself...

Whats the safest and best option to run my feed and return lines, The lines and exhaust are all I neeed to have this swap ready. I just want to make...

i have an L33 engine that i am unsure if it is a single or dual fuel lines. There are two tan colored lines that run down the back of the engine and...

Im looking for PCM printouts for a 2003 express 6.0. I can't seem to locate any that match my harness. Does anyone have these or know where I could...

I am about to undergo my first LS swap. I picked up a Very Very clean 96 3/4 ton 2 wheel drive Suburban for $900. It has a blown head gasket but a...

I have been searching and haven't been able to find a LSX conversion w/a 5.7. What I have currently is a 1997 K1500 4x4 w/a 4L60e tranny.. What...

I'm swapping a 4.8L from a '05 into a '93 Silverado. I'm going to put the 5-speed from the '93 behind the 4.8L and I'm using a 4.8L flywheel and the...

Frist let me say this is a very helpful site and to the crew at Nelson's these people are top notch to all you guys thank you the wiring harness and...

I'm putting the original getrag 5-speed behind a '05 4.8L into my '93 Silverado. My bellhousing has the fork and slave cylinder type throw-out...

Im installing a lq4 with the short crankshaft to a 700r4 in a 92 k1500. running into issues with the dust/torque convertor cover. I was wondering...

does any one know what hoses to use? mine are to long so the hoses tend to bend and restrict flow. trying to avoid cutting and making new ones.....

whats all needed to make this work besides changing the reluctor wheel..trying to put a 07+engine in a 2002

hey guys, I have a 70 c10 I just put an lq4 in. it has a cam, long tubes, and typical supporting mods. I'm running an aeromotive fuel pump and bypass...

My nelson harness arrived, I have it all plugged up on the engine and trans. I am going to start wiring it up over the next few days, everything...