All LS Based Conversions
Just Bought a 93 Crew Cab Dually for a project. Got a few questions as to problems i may run into. The truck started out as a diesel and had a 454...
Well bought a 1999 C5 with around 160 thousand miles. The Engine does not have the power of an even stock vette anymore. Raced my brothers stock 2002...
I have a 96 Tahoe with a leaking spider injection setup on the Vortec 350 now and a spare LQ9 that I am going to put im because the 350 has 150k...
So first off I'm horrible at keeping a build thread updated but I'll really try to finish this one. I had the frame, rearend, and suspension...
Why does everyone say when you do a 4.8 to 6.0 swap it will eat up a 4l60e tranny. What's the diff in building a stout 5.3 with the same power and...
i need a list of all the things i need to do this swap im going to pull a 6.0 and 4l80e out of a 2500 hd what all will i need to put it in my truck...
Is there any special caveats in terms of reluctor rings I should be looking for in the donor Lq9 or is it completely plug and play with all of my...
I have done alot of searching and just want to make sure i understand this correctly.i have a 1992 chevy pickup 2wd 5speed manual with a 2004 5.3...
I've searched n searched and can't really find if its ok to run the new wiring thru the stock hole on the pass side firewall. I'm mounting the PCM...
So I'm ready to get my fuel pump wiring done, I need to hook up the wire that turns on the fuel pump. I took apart the relay center and got the grey...
were is the best place to get wiring diagrams for my trucks wiring to marry my new harness to it.
B]Well this will be my official build thread on this truck, I am putting a LS1 out of a 2000 Camaro into my 04' Colorado which was a 5 cylinder 4l60e...
Hey guys. As some of you may know I got 6.0 swapped in my 95 a while back. But there is one thing I never finished. The gear indicator light on the...
been browsing the site gathering info for my swap, figured i would finally join to show the progress and ask some questions. bought this 94...
Anyone care to post up a pic of the adapter installed, also I cant find a adapter in brass anywhere,, where can I buy brass,, I don't want the chrome
#1, on a ls1 intake right below the MAP sensor there is a small vacuum port. What hooks up to it? Can I block it off or use it for a vacuum guage? ...
Just figured I'd share a little bit of my project with you guys. 1988 CrewCab Dually Was 454/th400 Now LS1/th400 I took a ton of pictures, but...
Here s a swap i worked on and off for a few months for my brother,harness by PSI conversion, Schonenfeld longtubes into 3" magnaflow 5x8s, 4.10 gears...
Hey guys and gals! This is my first time joining a forum and so far this place has been a very helpful. As of yesterday I picked up a 98 c1500...
Ok here is my problem, I bought a truck with a 6.0 swap, the trans was trash so bought a built 1. I'm not getting any fluid flow. So I talkd to...
Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules
