Forum: LSX Truck Conversions

my thruck started out as a base 4.3l 5 speed reg cab work truck 2003. I am in the prosess of swaping my 6.0l now a 6.6l into it . I need to know what...

Well it's gettin close to time for the A/C. What do yall think about these, do you think we could make them work?...

i have a 99 silverado it has intake and exhaust and it runs 16.5 and iwant to know what parts i can install to make it run 15.9 or faster

The PLAN is in my sig. Thanks for looking!! I think I should call this one JOE DIRT!!!! :laugh:

Hey i have a 93 silverado and i was looking into a Gen III 6.0L swap. Does anybody know if this is possible with the stock transmission and rearend?...

All the mounts worked out jut right. My factory driveshaft is perfect with the new motor mount positions. Minor fabrications to the trans crossmember...

Hello guys, i've been lurking around these forums and finally registered. I have an '89 reg. cab stepside that I'm going to flop (little more...

Hello , new guy here, I have been reading this forum for over a year now. First thanks to Redheart for his reco for installing an ls based engine vs...

When removing the egr valve is there a plate you can get to install in its place? I seen in the part numbers list a number for a plate. Is that for...

Well, the newly rebuilt 1998 LS1 and transmission are installed and working great! A little bit more fine tuning by the master programmer will be...

Here's where I am boys. I am hoping to get the engine and transmission in the truck this weekend. I am putting a T56 behind the 5.3L you see in one...

I've got everything out of the truck, and in the next day or two I'll be ready to drop in the LS2. My truck is a '98 Extended Cab 4WD, originally had...

I'm planning to do a ls1 swap into my truck. Is it worth the extra time and money to convert my 82 C-10 305/350 to a t-56 or try to find a 4l60e...

I BOUGHT A MAGNA CHARGER FOR MY 4.8 01, WHAT WOULD BE A GOOD CAM AND INJECTORS TO RUN WITH THIS. ALSO, HOW HARD WOULD IT TO GET THIS TRUCK IN THE...

does any one know where to get a new clutch? i blew mine up finaly 04 sc sb 4.8 nv3500

Top covers Ive never seen this before. Pretty cool. How do you cut and bend the acrylic?

looking to swap a 6.0l or 5.3l into my 2000 gmc sierra. just windering what all i will need to do so. any info would be helpful. :eek: thanks

Ok, I am trying to stab the engine in the frame (have the cab in place). I have the S&P plates. Pointed end towards the front, and the studs on the...

So to everyone that has done the Gen III swap into a 88-98, do you guys buy your adapter plates or do you make them?

I'm close to getting my 5.3 and T56 in my '92 but I still can't seem to get my hands around exactly what I need to retain from my original harness...