All LS Based Conversions
I just swapped a 2005 5.3/4l60e in to my 93 gmc c1500 and am down to a few minor things to finish it up. Gauge cluster is where i am at right now. ...
it seems that the general consensus is that the factor 96-up fuel pump is fine for the 5.3. But will the factory pump support the fuel requirements...
New to the site and getting my first swap going. A month ago I bought a 92 k1500 stepside with 350/nv3500 and am swapping in a LQ9/nv4500. I already...
Is an NV4500 behind a 6.0L LQ4 in a 4900lb truck going to feel like a lazy, heavy transmission? If so I'd rather go with a 4L80E I think. Thanks...
Well I have been lurking on different forums for a while now looking for a nice project to do my first LS Swap on finally found a truck. Just bought...
Hey guys, newbie to the forum, but have been lurking and doing a lot of research before this. I am thinking about getting a nice 88-98 c/k1500....
I have a 97 k1500 with the 5.7 vortec and the motor blew up I have access to a 04 Chevy k1500 complete truck and I was wondering how hard it is to...
Will the driveshaft from my 1994 GMC 1500 fit the tail end of a 2003 4l60??? The truck came with a 4l60..
Dropping in. Have had 2 ford lightnings over the last 7-8 years. Looking at a few single cab 5.3. Found a white one with a few mods 91,000 miles. LTs...
Greetings I'm a newbie here. New to the lsx but not new to wrenching . I have a few questions I hope someone can help. I have a 1995 gmc rcsbss that...
Ray and Vidal tackled this on Monday. Complete driveline in and using stock shaft. Schoenfeld long tubes Dirty dingo Custom NP harness. Btw...
Hey, I have done hours of research and know that they work together with a 4.8L fly wheel, 1377c release bearing, and 6302-vsp43 pilot bearing. ...
Hey guys, Just wanted to verify that my steam port location on the radiator is in a good place before I fire it up. I have the LS1 style 4...
Have a few questions about my swap in to a 93 gmc rcsb. Who here has gone with dbw and had functioning a/c? My engine/trans/harness/ecm is from a...
How many guys on here have done the conversion on an old square body? I have found a 00 extended cab with what is supposed to be a 5.3. My first...
Hello forum members I am doing a 5.3 swap on my 95 OBS single cab. I have read many threads and seemingly there are different opinions related to...
I am looking for the quickest and easiest way to install a 2002 LQ4 into my 97 chevy 4X4 with a 5.7 Vortec and 4L80e.......want quickest even if it...
Just wondering, how are you guys changing plugs on the rear two cylinders? My plugs are darn close to the back firewall, and the schoenfeld headers...
So I've finally pulled the trigger on doing my swap. I've already got started, so pictures will be limited and possibly kinda boring but most of you...
92 k1500 with nv3500 swapped in a cammed, fully bolted LQ9, that is Nelson tuned and am using a stand alone harness. Drove the truck for around 50...
Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules
