Forum: LSX Truck Conversions

Hi I have 6.0 engine out 2001 crew cab silverado 3500, VIN 1gcjc33u21f174906, my question is; It model has passlock ? Raùl

I have a 94rado w/ a 5.7 tbi,"power-aid" throttle spacer,MSD ignition,accel plugs/wires,mild cam,JBA shorty headders,h-pipe,dual flomasters........it...

Anyone know if this engine will go straight in? Truck has small block mounts.Also have the factory auto trans that came in the same car. Thanks for...

Hey all does anyone know what yoke i need to get to mate it to my t-56? i had heard a turbo 350 automatic would work looking for suggestions thanks

Sorry about the title ripoff 1BADC10 :laugh: Well, this is my topic about the 5.3L swap I am doing on my project truck. The project truck is my...

hey all when i pulled my motor i pulled the whole assembly for the master cylinder with it because i want to reuse it for my t-56 i detached the...

Im gearing up to start working on my fuel system for my swap into my 89' I plan on going with a fuel cell but dont know what fuel pump to go with...

Any pitfalls to look out for? Any advice? Medic_1 :ugh2:

Got all my wirring and plumbing done tonight so I thought I would see if it would start. Engine cranks fine and sounds like one cylinder is trying...

Whats up guys?! I'm currently working on an 88 silverado with a 6.0/4l80e swap. I need a wiring harness and have a chance to buy one from a wrecked...

Hey guys i just recently purchased a 2003 ls6 long block for a steal. I was wanting to put it into my 2004 Silverado and i was wondering what will i...

I am trying to remember if the gauge needle falls to empty when the ignition is/was shut off before the swap (again 1992 c1500 and he oe harnesses...

What do i need to do? I found a motor, do i need the wiring harness as well

so What do you guys think?

I have a 99 gmc 4.8L Will any Ls1 or Like LS6 intakes fit?

and got it started. It was the crank sensor wires. They had been mashed a little when the starter was pushed up by the frame. What did ya'll do to...

I got my new LQ9 in, now all I have to do is get the TKO-600 mated up, get the cam and valve train upgrade in from Nelson,,,,,, and in it will...

hey guys will this be the Y pipe i need for my 98 5.3 swap? Yall running the long tube pace setters! whoops heres the link! eBay Motors: LS1...

i got my project truck running its got 2002 Chevy Avalanche 5.3 with a comp 222/224 cam base tune :yippee: MySpaceTV: 97 silverado ls1 swap...