Forum: LSX Truck Conversions

I have a 1992 chevy 1500 with a 700r4 tranny. when i put the 5.3 in the truck will i have to switch tranmissions or can i run my 700?

Anybody interested in some engine mounts for the ls1 in a 98 or older chevy truck? I went thru my inventory, haha, at home and I have some...

wats the diff between these to motors? and were can i find pistons gaskets and such for the lq9 ive looked on summit jes and some other places im...

Hello Every One Im New To The Ls1 Family And Inquiring About This 96 Z71 Truck I Just Bought. I Also Have A Complete Ls1 ,wire Harness,...

Where do you get those pieces that snap on to the fuel lines on the 5.3 motor and adapt them to threads so you can run your braided fuel lines? ...

Went and got the motor today and started tearing it down, got the harness and intake off.

68 impala/ Lq4 swap -------------------------------------------------------------------------------- I am having the hardest time. I put a 6.0...

Can someone who has put a 5.3 into an 96-98 truck shoot me a PM I have some issues. Thanks Aaron

Is there anyway to check the milage on a GenIII motor after its been removed from the truck? Is it somehow stored on the PCM?

Hey guys I have a 2000 rcsb silverado with a 4.3 and 5 speed manual and what advise can I get on the 4.8, 5.3, or bigger I don't care but the 6 speed...

When I did my 6.0 install I didn't have the FPR hooked up to the vacuum line, reg went bad after a few weeks and fuel pressure was ~58 psi. Shortly...

2001 5.3 from Suburban, 2002 T-56 from Trans AM......which starter do I use??? I am assuming the one for the T-56 flywheel, so the LS1 starter? ...

thinkin about puttin an 01 lq4 into my 05 rcsb witha 4.3... is it ok to put a 2001 enigine in the 05? kinda a noobish question i know but just wanted...

i am wanting to put a new motor in my 01 ext cab and im not sure what motor to do i was wondering if u guys could help me decided i know the ls2 has...

?? My 5.3 doesn't originally have one in there...and the only reference i can find online is THIS picture <-- we will call that "radiused edge...

How much can I expect to pay for a 5.3 motor with the tranny and everything that goes with it? Would really like to keep it under 50,xxx miles...

Ok so regarding motor mounts, i seem to be getting some mixed reviews. I have a 10" lift on my truck, so I have already dumped a decent amount of...

Recently I've swapped a 2003 Chevy Avalanche 5.3l into my 1991 Nissan 240sx. The engine is backed by a 4l60e out of a 2006 2wd silverado. The only...

i have heard from various sources that a 2002 6.0/4l80e combo would be my best bet for the swap, believe has 317 heads and also uses the 0411 PCM...

Found a couple 6.0/4l80e packages locally from a few yards, going rate on the 02-era equipment seems to be right around $2000 with engine, trans,...