Forum: LSX Truck Conversions

hey guys, what engine mounts have you been using to mount your ls engine in your obs truck? specifically the body style around the '95 model. ...

first problem. egr port on manifold wont let header go in. second problem. non egr manifolds are the same casting just filled. so what manifolds...

When I went to the salvage yard where my 5.3l came from, the donor vehicle had the pedal but the tac module had already been robbed from it. When I...

Is a DBC intake on 04/05 6.0 the same as DBW intake?

what did you guys do about a power steering pressure line?

Will the oil pressure sensor from an '06 LQ4 work correctly with the 96-00 gmt400 oil pressure gauge? Or should I just use my stock sensor from my 99...

Okay, according to California's laws, you can legally swap a newer truck motor into an older truck. New engine must have all OE Smog equipment (? on...

Hello! I am looking to swap an 5.3 eng and 460le trans into my 85 4x4 stepside. Has anyone on this forum done this? Any info is appreciated. I...

I am wondering what you all are choosing to use for your air filtration on your swap. I have a special thing in mind but until I get to that am...

I am new to the LSX world and was wondering if a turbo 350 or 400 trans will bolt up to a 6.0

From what I understand is the cable operated throttle body will bolt directly up where my current DBW throttle body is. My question is this. Is the...

I am getting parts together for my lq4 98 chevy truck swap. What accessories and brackets do i use? Do I use the standard truck ones or cars or...

I know this isnt a truck but i know yall can answer my questions i have a 79 vette with a 355 in it swappin a lsx in it gna run a 5.3 ...

I hope I can explain this well enough. I recently finished a 5.3 swap in my 85 k10 and it runs great unless it sit for awhile idling. then it acts...

First off this is a great site, and I have read alot of good information already. I figured I would post and hopefully get some straight answers on...

have a lq9 6.0 outta an 02 3500hd im putting in my 82 swb truck. trying to figure out which fuel rails i can use on the factory 6.0 truck intake. i...

am going to do swap for my blazer but, I am confusing which engine to choose? The car will be daily driver, sand, mud, some street race for fun....

hey im just trying to figure out how to deal with this harness and computer. i rather run the fuse panel for protection of everything but im not sure...

I'm probably gonna use my 4l60e for now on my lq4 swap. Anybody know if there is a part number for the ecm to trans harness for the 4l60e?

anyone tried out the x-link 2.1 from torquerush performance? is it reliable ?