CC Dually LSX

[1BadCC]

Can the Nelson stand alone harness come with the electric fans wired in the harness or do you have to get it seperate. How much is the engine harness. Also if i use the stand alone harness It doesnt operate the guage correct. I would like to do away with the factory wiring as it has been butchered beyond repair.

[1BadCC]

Out with the old. Had to use the winch on the sxs to pull the hoist back. Ive got a lot of cleaning to do.

[1BadCC]

Finally got my adapters in after almost 3 months of waiting.

[Crazy Blu]

Hey ur lucky! Milled 24.5s or 22.5s goin on?

[DRAGGIN95]

Heck yeah, I can't wait to see the Semi's on there, it's going to be Sic!

[1BadCC]

Hey ur lucky! Milled 24.5s or 22.5s goin on?

22.5s for now, but going to build everything to lay out on 24.5s so i can go bigger if i decide to later on

[1BadCC]

Donor Truck

[1BadCC]

If any one needs parts hit me up

[Skyhighsami]

Just a word of advise since I had a 2005 Chevy 3500 diesel bagged. I did triple stack bags semi bags over the axle. They were HUGE but I got insane lift and only had to run 20 psi in them at ride height so it rode so smooth. In the front I ran RE7s I think they replaced the Slam Specialties I had that blew out when I broke a ball joint and they were so much better than the slam bags. I rode with 120 psi in the front with a diesel. One mistake I made was only getting 2 Viair 480s and 10 gallons of air. Get 3 compressors or 1 Oasis and 15 gallons minimum. One final suggestion, instead of doing the flex line I had all 1/2" copper line with all connections and splices sweat just like what's done on water plumbing. I didn't have any leaks or any potential for lines getting hot and melting. Metal Works in North Carolina is a good place to get parts to bag. My rear was 3 linked with the bag over axle and it would lay out and we towed a 30' enclosed trailer with a race car extra parts tools and 3 people's gear to TX2K10 running 80 mph at ride height which was lower than the truck was when I had it static dropped at 6-8.

[kerrige]

Just a word of advise since I had a 2005 Chevy 3500 diesel bagged. I did triple stack bags semi bags over the axle. They were HUGE but I got insane lift and only had to run 20 psi in them at ride height so it rode so smooth. In the front I ran RE7s I think they replaced the Slam Specialties I had that blew out when I broke a ball joint and they were so much better than the slam bags. I rode with 120 psi in the front with a diesel. One mistake I made was only getting 2 Viair 480s and 10 gallons of air. Get 3 compressors or 1 Oasis and 15 gallons minimum. One final suggestion, instead of doing the flex line I had all 1/2" copper line with all connections and splices sweat just like what's done on water plumbing. I didn't have any leaks or any potential for lines getting hot and melting. Metal Works in North Carolina is a good place to get parts to bag. My rear was 3 linked with the bag over axle and it would lay out and we towed a 30' enclosed trailer with a race car extra parts tools and 3 people's gear to TX2K10 running 80 mph at ride height which was lower than the truck was when I had it static dropped at 6-8.

You need to post pics in a new thread of said truck sounds sick!!!