Engine transmission angle?

[Shahnp1]

How attentive should I be to this? The engine and tranny are in now and their at about 5-6* down towards the rearend. I also lowered the truck (4-6) and the rearend is 8-10* up towards the tranny. I don't have the cab or bed on the frame just to make it easier, but I didn't know if it would change these angles or not. Oh, did I mention the engine and tranny are in the frame

Did you put any shims in between the leaf springs and axle to adjust ur pinion angle??? U will need to do that to keep ur pinion angle lined up right after 6"in drop in the rear

[RedHeartbeat]

yeah, driveshaft angle kills HP but when was the last time you saw the driveshaft angle on a severely lifted 4x4? Those things have scary driveline angles! They'll tilt the rear end to straighten out the pinion angle to the driveshaft but I wonder what happens when they no longer have oil on the bearings since the pinion angle is so pronounced.

[Shahnp1]

yeah, driveshaft angle kills HP but when was the last time you saw the driveshaft angle on a severely lifted 4x4? Those things have scary driveline angles! They'll tilt the rear end to straighten out the pinion angle to the driveshaft but I wonder what happens when they no longer have oil on the bearings since the pinion angle is so pronounced.

I know it look like it would tear it all to pieces, there no way its good for them

[NITROUS]

I'd set the pinion 3 degrees low to make sure there's no pinion to driveshaft interference. I leveled my motor and tranny out making adjustments to the crossmember and then set the rear drive shaft 3 degrees low. Trust me, if the pinion is too high it'll hit the driveshaft and knock the heads of the bolts off the pinion. Been there, done that! If you get a good bite on the pavement the pinion is going to the sky unless you have some ladder bars, Cal-tracs or a pinion stop. LOL

[Wtfan18]

how exactly do you measure the * prolly something ill wana know for my swap since i have a 4/6 drop aswell

[1BADC10]

how exactly do you measure the * prolly something ill wana know for my swap since i have a 4/6 drop aswell

I've done this by positioning the trans & pinion yokes such that the side of each yoke is parallel to the ground (to use somewhat of a flat surface). Placing the angle finder on the yokes will show you an angle measurement. Mine are within 1 degree of each other (4 & 5 degrees - trans & pinion respectively).