the things like seat belt, and warning lights were not compatable, so just took the led lights out and unpluged the message center, but just hooked the wires up like the drawing said and the important things worked. thanks again
the things like seat belt, and warning lights were not compatable, so just took the led lights out and unpluged the message center, but just hooked the wires up like the drawing said and the important things worked. thanks again
1987 jeep wrangler, 1999 LS 1, 4l60 231j transfercase, dana 30 frontend ford 8.8 rearend 3:73 gear ratio. sandersons shortie headers, 2.25 inch exhaust into 3 inch flowmaster muffler.
How did yo get to the leds??Originally Posted by oldcarstulsa
the cluster just pulls apart and exposes the leds
1987 jeep wrangler, 1999 LS 1, 4l60 231j transfercase, dana 30 frontend ford 8.8 rearend 3:73 gear ratio. sandersons shortie headers, 2.25 inch exhaust into 3 inch flowmaster muffler.
Did you have to remove the indicator pointers??
The back comes off of my 04 couple of clips are tricky. This exposes the rear of the board the front comes off but the LEDS are behind the face plate. I would have to remove the needles. I didn't try because i was told thats a bad thing to do, so i left them alone.
the 04 you have to take the pointer and all apart, the 02 that i have you just pull the back and all the gauge drivers and back plate just come off, so you can just unplug the leds, the 04 is a whole different beast
1987 jeep wrangler, 1999 LS 1, 4l60 231j transfercase, dana 30 frontend ford 8.8 rearend 3:73 gear ratio. sandersons shortie headers, 2.25 inch exhaust into 3 inch flowmaster muffler.
Posting Permissions
Reply With Quote