The shootout is coming up in a few weeks, I'll be busy getting ready. Good thing it was postponed for a month.

I need to install my 3deg shims on the rear leaf springs. Lowering your vehicle sometims angles the driveshaft and it gets out of wack.

I'll install my 8.1 L injectors, they are rated at 30lbs.

Do a little tuning to correct my idle and injector flow rate, definitely have to do a few WOT runs to set A/F ratio.

Install the cheapo traction bars I bought from Autozone, btw, they aren't that cheap, they are Lakewood, decent company. I painted these with some rubberized paint that is used for undercoating, they came out good
and i don't like the flashy look under the truck.

I want to also get my Painless Performance fuse block put in I jerry rigged the current setup, it works and holds up , just a little messy.

Lastly, I need to install my relay setup for my fans. They will be controlled by the pcm.


Later,


farmtruc