<div class='quotetop'>QUOTE(duckysbht @ Sep 21 2006, 09:33 AM) [snapback]65886[/snapback]</div>
What exactly does the controller read? Is it mainly used for tuning and are you able to use it with different tuning programs if it is used for tuning?
[/b]
Ducky,
It reads the Air/Fuel ratio. I have an AEM on my truck with a single sensor after the turbo. A dual sensor can read each bank of the motor to make them run in unison with each other. These allow for better tuning. They are usually install after the cats I think?
I use mine to make sure I do not run lean under boost. If I do its bye bye motor.
Jamest
12 Sec. Club! SOLD
La Viuda negra/ a.k.a. Black Betty
LQ4 6.0L, WCCH HEADS, LEVEL 5 FLT 4L80E TRANS. WITH TRANS BREAK, YANK 3200 STALL, TRICK TURBO, TURBONETICS T-76 TURBO, CUSTOM INTERCOOLED, 68lb INJECTORS, CUSTOM S/D TUNE FROM NELSON PERFORMANCE, COMP CAM 212/214 .557/.559 116+2, SNOW METH. KIT, . ALL INSTALLED AND DYNOED AT NELSON PERFORMANCE: 5**?HP @ 5073rpms and 5**TQ @ 4389rpms AT THE WHEELS WITH 10 PSI OF BOOST. ALL 3/4 TON TRUCK 5435LBS, NOTHING TAKEN OFF, STREET TIRES, AND USUALLY 2 BABY SEATS. WANNA RIDE?
SOLD***
Reply With Quote