you can drill and tap the side of the block where the 09 knock sensors bolt into and install your factory sensors since they are 1 wire, then just extend you wiring to the side of the block
you can also look into shoenfeld headers for your swap
you can drill and tap the side of the block where the 09 knock sensors bolt into and install your factory sensors since they are 1 wire, then just extend you wiring to the side of the block
you can also look into shoenfeld headers for your swap
06 rcsb, 6two, 231/235, 4.11, pacesetter, 80e, 14 bolt, Nelson tuned
2011 rcsb 6two swap in the works with 6l90 and boost
FARMTRUC CAN GARGLE PEANUT BUTTER
it has the knock sensors on the side already just a harness issue was all. wasn't sure if i could get away with just messing with the existing under intake knock sensor setup that was in the 4.8 vs. side of the block but ill give it a whirl . I figured it was the same wiring just different routing. ill look into those headers, thank you
Posting Permissions
Reply With Quote