Lots of pictures coming first time swap LQ9/5 speed going in a 92 k1500

[GreyChevy]

Got the wiring harness in and hooked up, starter bolted up, new slave cylinder installed, pedal assembly and module installed, drivers side header installed. About the only thing left is passenger header, Walbro fuel pump, LSradiator, LS electric fans, over flow tank, and swap the battery to the drivers side. Hopefully finish it up in the next few days.

[GreyChevy]

I have a lot of cleaning everything up to do but we fired it up! Installed the walbro fuel pump, passenger side header, and hooked up the battery. My buddy had no problem installing his longtubes but I had to dimple one of the primaries on the frame side and cut off an ear on the transmission to get it into place. Some people will prob shit a brick but instead of taking the bed off I cut an access door in the bed for the fuel pump. I'll clean it up real nice with hinges and then put my toolbox in place over it. Still need to install the radiator, overflow tank, new water pump, left side battery tray, air intake, and clean everything up....then drive it to get the exhaust done

[gagliano7]

I like the fuel door idea. Even though it isn't to bad to pickup the bed that still makes it a lot easier.

[GreyChevy]

Yeah, with the access door I can easily change it out by myself. Here's a quick video when we cranked it for a minute:

http://youtu.be/Wv_2R-bbyJw

[GreyChevy]

Haven't had a chance to work on it since my last post but will finally be finishing everything tomorrow and then going to the exhaust shop on monday

[91rcsb]

I may have missed it but what did you end up using for parts to mate the engine and trans?

[GreyChevy]

I used a 4.8 flywheel and a stock clutch for my 92.