newbie ish with a project thats about to be a bon fire

[bdydrped]

O and to add the the wish list..... part number for the shallow pan and pick up tube would also be greatly appreciated.

[farmtruc]

Ac can be accomplished, here's a '93 we did.
http://ls1truck.com/newstorage/twint...4%20(Copy).jpg

use shorty headers, with the 4.8L and shorty's, vs longtubes, you're really not going to miss that few hp.

if you're interested in a stand alone harness, we make a very nice show quality harness.

holley has a shallow pan you can use, or use the 2002 oem fbody pan.

[bdydrped]

thanks Farmtruc, i have looked at yalls site, little more $ then i have/want to spend on a harness at this point in time.. but is an option later. As far as the a/c and cutting the frame up, i looked at, measured and might go that route if i cant find anything else, just really didnt want to because i JUST base/cleared it after completing the Z and didnt want to have to disassemble everything and repaint unless that was the only last ditch option.

Ive read good and bad about the holly pan, as far as the casting being junky/cheap.

Thanks again for the input.