The tach doesnt work right and cannot get the coolant gauge to read properly. I know I can get the pcm values reset, but I do not want to send out the pcm again. Plus I want the factory style trans temp gauge.
The tach doesnt work right and cannot get the coolant gauge to read properly. I know I can get the pcm values reset, but I do not want to send out the pcm again. Plus I want the factory style trans temp gauge.
98 Sierra RCSB stepside, 5.3 swap, 4l60e. Go faster mods will begin soon!
Ok-Got it. The trans temp gauge is a pretty nice added feature.
Jeff
98 GMC RCSB 2wd, 100% internally stock 305, w/twin T-3 junkyard turbos,Ramjet intake w/42lb inj,12200411 PCM. 4675lbs w/me in it. Best time in 5 passes 13.01@110
Anyone??
98 Sierra RCSB stepside, 5.3 swap, 4l60e. Go faster mods will begin soon!
Nobody wants to give any hints on how they did the cluster swap?
98 Sierra RCSB stepside, 5.3 swap, 4l60e. Go faster mods will begin soon!
I think I've only seen one real working cluster swap and I believe he used the harness and all from the newer truck. Everybody talks about doing it but it usually ends up being more trouble than it's worth. If your just wanting to do it to get all your gauges working that's probably not the easiest way. The tach and temp gauges are not hard fixes compared to a whole cluster swap. Just my .02
97 RCSB . 2WD . 5.3 . 4l60E . E-FANS . PNP 706s . TSP 228R . 3600 STALL . HD2 . VETTE SERVO . 3.73s . 2" DROP
TURBO IN THE WORKS
I've been researching this myself. Not sure what year your motor is? The research I've done is on the 2007 & newer gauge clusters. I'm not sure how much of the following is relevant to pre-2007. That said, you need to run a BCM. The BCM is the gateway between the low speed bus and the high speed bus. The cluster is on the low speed bus and all of the data it needs is on the high speed bus. I've seen at least one thread where it was done. A lot of work and troubleshooting, but doable. If your main goal is just the tranny temp, there are several easier ways to go. http://www.aeroforcetech.com/ http://www.scangauge.com/products/scangaugeii/
1992 K1500 Blazer.
L94 & 6L80
14 Bolt SF axle w/11" brakes & appropriate Combination brake valve, Eaton Trutrac rear posi.
8000# hidden winch, Rocket Box, KYB Monomax shocks
285/75R16 Duratracks
Flat Panel Display Gauge cluster in progress.
http://www.ls1truck.com/forums/lsx-t...00-blazer.html
New interior & exterior paint planned.
Posting Permissions
Reply With Quote