Anyone running holley hi ram intake?

[silveradorider04]

Yea stock maf ill be going SD pretty soon, just a cheap ass ebay tube with a k&n filter I refuse to spend a huge amount of money on a cai when its just a hollow tube. Ebay I think it was 50 $ came with its own filter bu I had a k&n that fit it.

Thanks for info. We may end up going SD tune rather than MAF but wanted info just in case.

[skeet]

[canada4g63]

why run the high rise? what are you spinning to?

[skeet]

why run the high rise? what are you spinning to?

motor is built to turn RPM so it depends on intake used along with headers and everything else! as of now this setup hasnt been dynoed so im not sure where it needs to spin up to as of yet, as of now i turn 7300-7500 but like mentioned i could be over spinning her who knows a dyno will tell the tale

[George C]

have this intake for a boosted setup but we welded a 90* elbow right to the throttle body and ran the charge pipe down in front of water pump

[banker099]

[kainedogg]

That is a good looking intake. Is it ideal for boosted applications as well?